Hardware Installations and Upgrades
24
Intel
®®
Server System R1000BB Service Guide
5.
Repeat steps C and D by giving each screw two rotations each time until each screw is lightly
tightened up to a maximum of 8 inch-lbs torque (see letter “E”).
6.
Figure 33. Installing Processor Heatsink
Removing the Processor
1.
Remove the processor heatsink, see Figure 26.
2.
Open the socket lever, see Figure 27.
3.
Open the load plate, see Figure 28.
4.
Remove the processor.
Installing and Removing Memory
Installing Memory
1.
Locate the DIMM sockets. Make sure the clips at either end of the DIMM socket(s) are pushed
outward to the open position (see letter “A”).
2.
Holding the DIMM by the edges, remove it from its anti-static package. Position the DIMM
above the socket. Align the notch on the bottom edge of the DIMM with the key in the DIMM
socket (see letter “B”).
3.
Insert the bottom edge of the DIMM into the socket (see letter “C”). When the DIMM is
inserted, push down on the top edge of the DIMM until the retaining clips snap into place (see
letter “D”). Make sure the clips are firmly in place (see letter “E”).