Intel P4304SC2SFEN, User Manual

Page: 10 / 18

6
General Installation Process
E
F
B
A
Install Hard Drive ... Continued
3.5" Hot-Swap Hard Drive Carrier (For system with 3.5" hot-swap hard drive bay only)
A
Open the Hot-swap door and
remove the drive carrier by
pressing the green button and
opening the lever.
Slide the carrier out.
B
Remove the four screws securing the
HDD interface bracket and remove the
HDD interface bracket.
C
Install the hard disk drive using the
same four screws as shown. Make
sure the connector end of the drive
matches the backplane connector.
D
CAUTION: If you don’t install all
drives, empty drive bays must
be occupied by carriers with
plastic drive blank provided to maintain
proper system cooling.
With the lever open, insert the
hard disk drive assembly into the
cage opening and push until the
locking lever engaged.
Push in the lever to lock it into
place, then close the door.
E
F
TOP
BREAK OFF T
AB
BEFORE MOUTING
2.5´´ HARD DRIVE
C
3.5´´ HDD
D
A
B
Press the clip.
B. Install the Hard Disk Drive C. Install the EMI shield
A
B
Secure the 3.5" or 2.5"
HDD on the HDD carrier
tray with screws.
Pull out the HDD
carrier tray.
C
Insert the HDD carrier
tray into chassis.
A
B
C
Press the clip.
Fit the edges of the EMI Shield against
the sides of the chassis.
A. Remove the EMI
shield
Lift the EMI shield and
move EMI shield outward
from the chassis.
9
A
B
A
3.5" HDD
2.5" HDD
B
Install Hard Drive
Fixed Hard Drive Carrier (For chassis with fixed hard drive bay only)
C
A
A
C
B
Slide the EMI Shield downwards until
the latches on the EMI Shield are
engaged with the chassis.