Hardware Installations and Upgrades
30
Intel
®
Server Chassis P4000M Service Guide
6. Use screwdriver to release the hotswap hard drive cage (see letter
A
) from the chassis and remove
the hotswap hard drive cage (see letter
B
).
Figure 48. Removing the 4x3.5” HDD Cage
7. Lift the EMI shield (see letter
A
) and move EMI shield outward from the chassis (see letter
B
).
Figure 49. Removing the EMI shield
Installing 4x3.5'' Hotswap Hard Drive Cage with Backplane
CAUTION
It is critical that you connect the SAS/SATA data cables correctly from the SAS/SATA backplane to
your server board or RAID controller card. Failure to do so may result in data loss.
1. Observe the safety and ESD precautions at the beginning of this book.
2. Power down the server and unplug all peripheral devices and the AC power cable.
3. Remove the chassis cover. For instructions, see “Removing the Chassis Cover”.
4. Remove the front bezel if it is installed. For instructions, see “Removing the Front Bezel”.
5. Install the hotswap EMI HDD shield under the hotswap cage.
Summary of Contents for P4000M
Page 14: ......
