Intel M70KLP Series, Service Manual

Page: 45 / 109

Intel® Server System M70KLP Family Service Guide
43
3.4 DDR4 DIMM / Intel® Optane ™ PMem Installation
This section describes adding a standard DDR4 DIMM or Intel® Optane™ PMem device to an existing memory
configuration. For replacement instructions, see Section 5.2 .
DDR4 DIMM and Intel® Optane™ PMem will be commonly referred to as “Memory Module ” in the following
instructions.
Note: The system requires that all memory slots be populated with either a memory module or a DIMM
blank. Pre-installed DIMM blanks should only be removed when replacing it with an actual memory module.
When removing a memory module from the system, it must be replaced with an equivalent device or
supplied DIMM blank.
Required Tools and Supplies
• Anti-static wrist strap and ESD safe workbench
System Prerequisites
• The system must be powered off and AC Power cord(s) disconnected
• Remove the system top cover and air duct – See Section 2.1
Figure 50. DIMM Blank Removal
1. Remove the DIMM blank from the desired memory slot.
• Open the ejection tabs at both ends of the selected memory slot to lift the DIMM blank from the
slot (see Letter A).
• Carefully remove the DIMM Blank from the system (see Letter B).