Intel® Server System M50CYP2UR Family System Integration and Service Guide
99
6.5
Memory Module Replacement
Required Tools and Supplies
•
Anti-static wrist strap and conductive workbench pad (recommended)
Only standard DDR4 DIMMs are shown in the following figures, but the steps of DDR4 DIMM installation and
replacement are the same for standard DDR4 DIMMs and Intel® Optane™ DC persistent memory
200 series
modules.
DDR4 DIMM and Intel® Optane™ PMem will be commonly referred to as “Memory module” in the following
instructions.
Note:
for general memory population rules.
Figure 123. Memory Module Removal
1.
Ensure the system power is off and disconnect the power cable(s).
2.
Remove the system top cover (see
Section 6.1.1
).
3.
Remove the air duct (see
Section 6.2.1
4.
Identify and locate the Memory module to be removed.
5.
Ensure that the ejection tabs of adjacent DIMM slots are closed.
6.
Open the DIMM ejection tabs at both ends of the selected DIMM slot (see Letter A). The Memory module
will slightly lift from the slot.
7.
Holding the Memory module by its edges, lift it away from the slot (see Letter B).
