Intel® Server System M50CYP2UR Family System Integration and Service Guide
26
2.4
Processor Assembly and Installation
Components Required:
•
3
rd
Gen Intel® Xeon® Scalable processors
•
Processor carrier clip
•
Standard 2U heat sink or standard 1U heat sink
•
Processor tray (comes with the processor)
Required Tools and Supplies
•
Anti-static wrist strap and conductive workbench pad (recommended)
•
T-30 Torx* screwdriver
•
ESD Gloves
The Intel® Server System M50CYP2UR family includes two Socket-P4 LGA4189 processor sockets
compatible with the 3
rd
Gen Intel® Xeon® Scalable processor family.
Two types of heat sinks are supported for the Intel® Server System M50CYP2UR family: Standard 2U heat
sink and standard 1U
heat sink. The type of heat sink used depends on the system configuration and its
thermal requirements. Server systems using the GPGPU air duct must use the standard 1U heat sink.
Figure 12. Supported 2U Processor Heat Sinks
The Intel® Server System M50CYP2UR family includes two Socket-P4 LGA4189 processor sockets
compatible with the 3
rd
Gen Intel® Xeon® Scalable processor family.
A processor heat sink module (PHM) assembly and processor socket assembly are necessary to install a
processor to the server board.
identifies each component associated with the PHM and processor
socket assemblies.
Note:
The following sections show the standard 2U heat sink in the figures, but the procedures described
apply to both heat sink types.
