Intel® Server System M20MYP1UR System Integration and Service Guide
18
2.3.1
PHM Assembly
Figure 6. Processor heat sink handling
1.
Remove the heat sink from its packaging. To avoid damage to the heat sink, grasp it by its narrower, top
and bottom edges, as shown above.
Figure 7. PHM Assembly
–
Heat sink orientation
2.
Place the heat sink bottom side up, on to a flat surface as shown above.
3.
If present, carefully remove the plastic protective cover from the bottom side of the heat sink to expose
the Thermal Interface Material (TIM).
4.
Locate the processor clip and place it on to a flat non-skid surface with corner latch pins facing down.
5.
Carefully remove the processor from its packaging.
A processor should only be grasped by its edges.
Do not touch any part of the component side of the processor with your fingers
.
