Intel® Server System M20MYP1UR System Integration and Service Guide
17
2.3
Processor Assembly, Installation, and Replacement
Components Required:
•
1 or 2
2
nd
Gen
Intel® Xeon® processor Scalable family
•
1 or 2 processor clips
•
2 1U processor heat sinks
Tools Required:
•
T-30 Torx screwdriver
•
Flat head screwdriver
•
Adequate ESD protective gear (wrist strap, ESD mat)
This generation of Intel Server Systems requires that the processor be attached to the heat sink prior to
installation on to the server board. The processor / heat sink assembly is referred to as the processor heat
sink module, or PHM.
Figure 5. Processor heat sink module (PHM) reference diagram
To properly assemble the PHM and install it to the server board, the procedures described in the following
sections must be followed in the order specified. These instructions assume that all the PHM components
are new and the Thermal Interface Material (TIM) is already applied to the bottom of the heat sink.
