JBOD 2000 Internal Connection Overview
Intel® Storage Server System JBOD 2000 Family Hardware Guide
Revision 1.42
40
Table 24. 12x3.5” Single-port JBOD 2000 Internal Components
Label
Description
Label
Description
A
Front Panel
B
Front Panel Cable
C
HSBP Power Daisy Chain Cable
D
Three 60mm System Fans
E
2x15-pin Front Panel Connector on PDB
F
1x4-pin Expander Power Connector on PDB
G
Expander Power Cable
H
SMBus Connector on PDB
I
Four 2x4-pin HSBP Power Connectors on
PDB
J
2x25-pin PSU Connector on PDB
K
SMBus Connector on Expander
L
PSU
M
External mini-SAS Cable (need to order
separately)
N
SFF-8088 Connector on SAS Converter
0 Port Label: A PRI
1 Port Label: B PRI
O
Primary SAS Interface Board (SFF-8087 to
SFF-8088)
P
SFF-8087 Connector on SAS Converter
Q
Expander Power Connector on Expander
R
SMBus Cable
S
Primary SAS Expander
T
Fan Cable
U
Three mini-SAS Connectors on HSBP with
port number
V
12x 3.5” HSBP
The following diagram is used to help identify the mini-SAS connectors found on the SAS
expander cards. Take care when connecting the connectors from the SAS expander to the
connectors on the backplane because each connector is pre-programmed at the factory to
provide specific drive identification mapping. Improper connections may provide undesirable
drive mappings. By default, the Intel
®
Storage Server System JBOD 2000 Family has all internal
mini-SAS cables connected.
Figure 35. Primary SAS Expander
