2.19
Installing and Removing the VGA (Video) Debug Cable
The S7200AP Video Debug Cable Option is a VGA video cable that connects to the internal header on the
S7200AP board and can be routed through the Riser 1 bracket on the rear node panel when used with the
HNS7200AP product. The cable is intended for debug use when deploying S7200AP-based systems and is
not intended for normal product operation. Refer to the
S7200AP Family Configuration Guide &
Spares/Accessories List
for ordering details.
2.19.1
Installing Video Debug Cable
1.
Power off the compute module and disconnect the power cable(s).
2.
3.
Remove the Slot 1 Riser and the PCIe* adapter if there is one installed
.
4.
Remove the video cable from the package
5.
Route the video cable through Riser 1 bracket as shown in Figure 86
Figure 87. Video Cable Routing
6.
Plug in the cable into the correct board header (
J1B1
) prior to installing Riser 1 back into the slot. The
connector is keyed, so ensure that the orientation is correct (See
A
).
Figure 88. Connecting video cable to board VGA connector
