Intel HNS2600TP series, Service Manual

Page: 42 / 55

Intel® Server Board S2600TP and Intel® Compute Module HNS2600TP Product Family
30
2.13.2 Installing the SAS/PCIe* SFF Combo Bridge Board
1. Attach the plastic holder to the front end of the bridge board (see letter A ).
2. Insert the bridge board into the slots on the server board (see letter B ).
3. Secure the bridge board to the side wall with the six screws (see letter C ).
Figure 61. Installing the SAS/PCIe* SFF Combo Bridge Board
2.14 Replacing the Server Board
2.14.1 Removing the Server Board
1. Remove the air duct. See Removing the Air Duct .
2. Remove the processors and the memory DIMMs if there are any. See Removing the Processor and
Removing the Memory .
3. Remove the bridge board. See Removing the Bridge Board .
4. Remove the PCIe* riser assembly from the riser slot 1. See Removing the PCIe* Riser Assembly – Step 1
and Removing the PCIe* Riser Assembly – Step 2 .
5. Remove the IOM riser and carrier assembly from the riser slot 2 if there is any. See Removing the IOM
Riser and Carrier Assembly .
6. Disconnect the cables from the server board.