Intel® Server D50TNP Family Integration and Service Guide
171
7.12
Accelerator Module Riser Card Replacement (iPC
–
D50TNP2MFALAC Only)
The following provides instructions for the replacement of the riser card for the accelerator add-in card on
the Intel® D50TNP Accelerator Module (D50TNP2MFALAC).
Required Tools and Supplies:
•
Anti-static wrist strap and conductive foam pad (recommended)
•
Phillips* head screwdrivers #1 and #2
1.
Remove the accelerator riser assembly from the Accelerator Module. Follow steps 1 through 11 of
Section 7.11.
2.
Remove the accelerator add-in card from the accelerator riser assembly. Follow steps 12 through 15 of
Section 7.11.
Figure 252. Accelerator Riser Assembly Rear Bracket Removal
3.
Using Phillips* head screw driver #1, remove the screws that secure the rear bracket to the riser assembly
(see Letter A).
4.
Slide the rear bracket and remove it from the riser assembly (see Letter B).
Figure 253. Accelerator Riser Card Removal
5.
Using Phillips* head screw driver #2, remove the screws that secure the accelerator riser card to the riser
assembly (see Letter A).
6.
Remove the accelerator riser card away from the riser assembly (see Letter B).
