Embedded Intel® Atom™ Processor N2800 with Intel® NM10 Express Chipset Development Kit User‘s Manual
79
Figure 24. Installing a PCI Express Mini Card in the Half-Mini Card Slot
3.6.4
Connecting to SATA Drive Considerations
This Development Kit supports two SATA drives with two data connectors and one power
connector. To enable low-profile connectivity, the board ships with two SATA data cables
with right-angled connectors and an in-line power cable that provides:
•
a right-angled female-gender 15-pin SATA power connector for low-profile board
connectivity
•
a female-gender 1 x 4 Molex-type power connector for system component power
flexibility
•
a 15-pin female-gender SATA power connector for SATA drive power
•
a vertical 15-pin female-gender SATA power connector for SATA drive power
NOTE:
If you install an mSATA drive in the board’s PCI Express Full-/Half-Mini Card slot, SATA port 1 (gray) will
be disabled.
To connect a SATA drive to the Embedded Board N2800:
1.
Observe common sense ESD precautions
2.
Attach the right angled connector on the SATA data cable to one of the SATA
connectors on the board (see Figure 25
A).
3.
Attach the other end of the SATA data cable to the SATA drive (see Figure 25
B).
4.
Attach the right-angled 15-pin SATA power connector on the power cable to the
15-pin SATA power connector on the Desktop Board (see Figure 25
C).
5.
Attach the 15-pin SATA power connector (see Figure 25
D)
