Intek Elite Version 8D, Installation & Programming Manual

Page: 32 / 56

Page 32
DIALER PROGRAMMING SECTION
The Dialer section of this alarm panel has many different programmable options. Some of these options require
special function keys to select or program the options when entering telephone numbers or 4+2 codes. These special
function keys and their corresponding keypad LED indications are listed in the following table.
DIALER PROGRAMMING OPTIONS
This address (P185E) is used to turn the dialer on and select other dialer related options.
P185E 1E Dialer is Enabled - Default off
2E Fax Defeat - Default off
3E Disable Telephone Line Monitoring - Default off
4E DTMF or Pulse Dialing - Default off (NOTE: Options 4 & 5 must be OFF for DTMF Dial)
5E DTMF or Reverse Pulse Dialing - Default off (NOTE: Options 4 & 5 must be OFF for DTMF Dial)
6E Spare - Default off
7E Auto-detect Modem - Default on
8E Bell 103 or V21 - Default off
Option 1
Dialer is Enabled - If this option is turned off the dialer will be disabled. The option must be on to allow
the dialer to make calls.
Option 2
Fax Defeat - The panel can answer an in-coming call in two ways. The first is to set the auto-answer
ring count to a convenient number (P249E) and let the phone ring until this number is reached at which
time the panel will answer the call. The second method is to use fax defeat which entails calling the
panel and letting it ring no more than 4 times, hanging up, then ringing back within 45 seconds. The
panel will now answer the call on the first ring.
Option 3 Disable Telephone line Monitoring - If the panel is connected to a poor telephone line and the line
failure alarm is appearing regularly, by turning this option on the panel will not do the line test.
Option 4
DTMF or Pulse Dial - If this option is On then the panel will dial using Normal Pulse Dialing format (eg
the number 9 = 9 pulses) NOTE: Options 4 & 5 must be OFF for DTMF Dial
Option 5 DTMF or Reverse Pulse Dial - If this option is On then the panel will dial using Reverse Pulse Dialing
format (eg the number 9 = 1 pulse) NOTE: Options 4 & 5 must be OFF for DTMF Dial
Option 6
Spare
Option 7
Auto-detect Modem - If this option is on the panel will answer an in-coming call with the V21
acknowledge tone. If the modem does not respond within 5 seconds the panel will then generate the
acknowledge tones for Bell103 format. It will repeat this cycle twice and then hang-up if no
LED KEYPAD
BUTTON
LED KEYPAD
INDICATION
LCD KEYPAD
BUTTON
4+2 FUNCTION TELEPHONE NUMBER
SPECIAL FUNCTION
“
0
”
ARMED A 0
“
0 or A
”
N/A
“
PANIC
”
READY/EXCL CONTROL & 2
“
B
” “
#
”
“
MEMORY
”
SYSTEM CONTROL & 3
“
C
” “
*
”
“
CONTROL
”
TROUBLE CONTROL & 4
“
D
” “
2.5 sec Pause
”
“
ARM
”
READY/EXCL
SYSTEM
CONTROL & 5
“
E
” “
Wait for 2nd Dial-tone
”
“
MONITOR
”
READY/EXCL
TROUBLE
CONTROL & 6
“
F
” “
5 sec Pause
”