AMBUS® Link
11
5.1.1.
Power supply:
1. Assure that the power cable
is voltage-free!
2. The disconnector needs to be switched
off!
3. Flip up the protective cover
4. Loosen the terminal connection
(terminal 9 (+24V DC) /10 (GND))
5. Connect the power supply
to
terminal 9 (+24V DC) /10 (GND).
6. Tighten the terminal connection
7. Close the protective cover
AMBUS
®
Link is ready for use
5.1.2.
Attach the protective covers
1. Attach included protection cover
with
slight pressure
2. Attach included protection cover
with
slight pressure
3. Attach included protection cover
with
slight pressure
The interfaces are protected
5.2 M-Bus network (field level)
In the following the installation of the M-Bus network with AMBUS
®
Link is described
ATTENTION
Material damage caused by neglected installation conditions
Danger of malfunction or damage!
•
Generously dimension the main cable cross section and possibly
divide it into 3 terminal groups
•
Apply voltage only to the intended terminals
