12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.IN
TEC
| relevantsolutions.com/inteccontrols
Specifications subject to change without notice. | USA 160811 | Page 7 of 34
MGC2 – UserManual
PolyGard
®
is a registered trademark of MSR-Electronic GmbH
4 Menu Overview
The Gas Controller MGC2 is operated via a simple and logical menu structure which is easy to learn. The operating
menu contains the following levels:
● Starting menu with date and time if no SP is registered, otherwise scrolling display of the gas
concentrations of all registered transmitters in 5-second intervals
● Main menu
● Submenu 1 and 2
INTEC
13.06.13 1:45am
Display of gas
concentration
Power On Time
Power On Time
Main menu
After 30 sec.
Starting menu
System Setup
Reading and change of the system parameters
See Section 4.7
Data Logger
Reading and change of the data logger parameters
See Section 4.8 (available from version 9.02)
SP Setup
Reading and change of sensor point parameters
Activate or Deactivate SP
Assignment of the alarms to the alarm relay
See Section 4.6
Relay Setup
Reading and change of the relay parameters
See Section 4.5
Sensor Readings
Display of the sensor values
See Section 4.4
Relay Status
Display of the relay status
Manual operation of the relays
Reset function of the relays
See Section 4.3
Stage Status
Display of the status of actual alarms
See Section 4.2
System Errors
Reading and reset of errors
See Section 4.1
or
