Intec Controls PolyGard MGC2-04, User Manual

Page: 26 / 34

12700 Stowe Drive, Suite 100, Poway, CA 92064 | Ph: (858) 578.7887 & (888) GO.IN TEC | relevantsolutions.com/inteccontrols
Specifications subject to change without notice. | USA 160811 | Page 26 of 34
MGC2 – UserManual
PolyGard ® is a registered trademark of MSR-Electronic GmbH
4.8.1 Service Mode
For calibration and service work, the alarms are not transmitted to the alarm relays when the service mode is active
(ON). The service mode ON is reset automatically after 60 minutes or manually in the menu “Service Mode”.
Symbol Description Default Status Function
OFF Service Mode OFF
OFF = Alarms activate the associated alarm relays
ON = Alarms are not transmitted to the alarm relays
4.8.2 Software Version
Symbol Description Default Status Function
GC05-XX Software Version XX = Software Version
4.8.3 SP Address Mode
This configurable functionality is available from version 9.02.
Adaptation of the value and parameter display to the connected field bus transmitters.
Symbol Description Default Status Function
98 Addr. a
1 SP
SP Addr. Mode 98 Addr. a 1 SP 98 Addr. a 1 SP = transmitters
4.8.4 Language
This configurable functionality is available from version 9.02.
Selection of the menu language
Symbol Description Default Status Function
USA English Language USA English
English
German
Dutch
USA English
French
Swedish
4.8.5 Maintenance Concept
A control of the maintenance intervals required by law or by the customer is integrated in the MGC2 system.
At commissioning or after maintenance the date for next maintenance is entered. When this date is reached, the
failure signal is activated the next morning at 9 o’clock, and the phone no. of the service technician occurs in the
display instead of the measured values. The text message “Maintenance” and the service phone no. can only be reset
after having accomplished the maintenance by entering the next maintenance date.
The service phone no. can be entered individually in the next menu.
Symbol Description Default Status Function
MM.DD.YY. Maintenance date MM.DD.YY. = Input of the date for next maintenance.
0853.... Phone No. Input of the individual service phone no.