INSYS GSM 4.3 I4, Manual, Page: 65 / 78

INSYS GSM 4.3 I4 Functions
65
11.25 Manual Sending of Messages
The collective message or the individual pulse messages can be sent manually.
Configuration with HSComm
A manually triggered dispatch of the messages with the HSComm software is
not possible.
Configuration with AT commands
In order to send the commands , use the com-
mand
Replace
<input>
with the number of the in-
put, for which the SMS is to be sent.
Replace <pulse_no> with the pulse number,
for which the SMS is to be sent (1…10). If a sin-
gle alarm is configured, 1 must be entered
here.
AT**SMS=<input>,<pulse
_no>
If the messages 1 to 10 are triggered, the sent message will always consist of
the collective message and the attached pulse message. The message will be
sent to the configured recipient number as well as all possibly configured ad-
ditional recipients.
11.26 Operation with a PLC
The INSYS GSM 4.3 I4 can be operated at a programmable logic controller. Settings rec-
ommended by INSYS for a INSYS GSM 4.3 I4, which is used at the PC to communicate
with the PLCs, are available for certain controllers. The respective configuration files can
be found under http://www.insys-tec.de/en/en/plc/ or in the “Configuration for PLC”
section of the CD delivered with the unit.
Configuration with HSComm
You may load setting files into HSComm under the menu item “PLC”. More-
over, you can store settings for the PLC to a file. You can send these settings to
the INSYS GSM 4.3 I4 then.
Configuration with AT commands
You can also perform these settings with AT
commands. The settings depend on you PLC
and cannot be given here generally therefore.