EloStar Master 3X0 / 4X0 / - smart
Operation
Manual V.1.03H
64
7.12.3
Triggering Silent Alarm When Opening
Not evaluated by UL. This option, which depends on configuration, is a way
to send a message calling for help without being noticed doing so. The
alarm can
not
be triggered
via Chip card
. When entering PIN code, trigger
the alarm by carrying out the steps listed below.
Settings
Boxes
PIN code
,
Release
,
1 0f 3
and
Open locks
of the user matrix have been marked for you. The lock
master has registered your PIN code at the lock
. ‘Silent
alarm’ has been activated via software TwinComm.
Take
an activated device TwinXT / TwinAlarm and a burglar (intruder)
alarm system (BAS / IAS).
1.
Press key
Enter
and release it after a second.
The system checks its status. Date and time are on display.
2.
With menu key
<
or
>
select
Open
and confirm with key
Enter
.
With 2 or 3 locks in the system,
Lock: 1
is on display.
3.
If required, select the lock with menu key
<
or
>
and press
Enter
.
Code entry | User: Master
is on display.
If you confirm with
Enter
,
Master | PIN code
is on display and you open as
‘master’.
4.
Present your user identification data.
Also see
‘User- / Personnel Numbers’ on page 51.
User no. | PIN code
is on display.
5.
Confirm with
Enter
.
User Nr
,
0123456789
, as the case may be, and
Code:
are on display. Also
see ‘Entering PIN Code’ on page 57.
6.
Enter all the numbers of your code but the last one.
7.
Instead of the last number (‘8’, for example) take its value (8) and add the value
which has been set in TwinComm USB for ‘Silent alarm’ (ex works ‘1’, value
range 1-9) and confirm with
Enter
.
If the result should turn out a two-digit
number, instead of sum ‘11’ enter 1, instead
of ‘12’ 2, instead of ‘13’ 3 etc.
The messages displayed and, if required, additional further opening procedures
are the same as those of a standard opening process.
You have successfully triggered silent alarm.
