INSYS ADSL 1.1
Assembly
23
9
Assembly
This section describes how to mount the INSYS ADSL 1.1 to a DIN rail,
connect the power supply and uninstall it again. Observe the instructions in
the "Safety" section of this manual, in particular the "Safety Instructions for
Electrical Installation" for that purpose unconditionally.
Caution!
Moisture and liquids from the environment may seep into
the interior of the INSYS ADSL 1.1!
Fire hazard and damage of the product.
The INSYS ADSL 1.1 must not be used in wet or damp
environments, or in the direct vicinity of water. Install the
INSYS ADSL 1.1 at a dry location, protected from water
spray. Disconnect the power supply before you perform
any work on a INSYS ADSL 1.1 which may have been in
contact with moisture.
Caution!
The device could be destroyed if the wrong power supply
is used!
If the INSYS ADSL 1.1 is operated with a power supply
that supplies a voltage exceeding the permissible
operating voltage of the INSYS ADSL 1.1, the device will
be destroyed.
Make sure that you use the suitable power supply. Refer to
the Technical Data section for the proper voltage range of
the INSYS ADSL 1.1.
