i-modul ISDN HIX V4
Functions
6.6
Control Outputs
The i-modul ISDN HIX V4 provides two control outputs, OUT1 and OUT2. They can
be controlled independently of each other via AT commands. The outputs can also
be switched via remote configuration. The outputs remain in a state until this is
changed by a switch command.
The state of the outputs can be queried in the status registers (S registers) S14
(output 1) and S15 (output 2).
Both outputs are not connected to GND in default setting.
Configuration with AT commands
To switch the outputs use the command
The following applies:
<Out>
is "0" for
output 1 and "1" for output 2 and
<state>
is "0" for Off and "1" for On.
AT*Y<out>,<state>
In order to enable output 1, use the
command
AT*Y0,1
In order to disable output 2, use the
command
AT*Y1,0
31