i-modul ISDN HIX V4
Functions
If the remote terminal accepts the
connection, the i-modul ISDN HIX
V4 indicates
CONNECT
If the remote terminal is busy, the i-
modul ISDN HIX V4 indicates
BUSY
If no connection can be
established, the i-modul ISDN HIX
V4 indicates
NO CARRIER
if the i-modul ISDN HIX V4 cannot
start a dial-up procedure, it
indicates
NO DIALTONE
In order to change to command
mode during a data connection,
use the escape sequence
No data must be transmitted for 1
second before and after that the i-
modul ISDN HIX V4 changes to
command mode.
+++
In order to change from command
mode to normal data transmission
again, use the command
ATO
In order to accept an incoming
connection, use the command
ATA
In order to configure the number of
ring tones after which the i-modul
ISDN HIX V4 answers and accepts
the connection, use the command
Replace
<n>
with the number of
ring tones.
ATS0=<n>
In order to terminate a connection
and cause the i-modul ISDN HIX V4
to hang up, use the command
ATH
19