Instron 2716 Series, Operating Instructions Manual

Page: 19 / 36

19
Jaw faces
Product Support: www.instron.com
Table 3. Jaw face compatibility
Cat. No. Face Type
Serrations per
in. Specimen Size/mm (in.) Use with grips
2703-001 Flat 16 0 to 6.4 (0 to 1/4) 2716-002 or 2736-004
2703-002 Flat 16 6.3 to 12.7 (1/4 to 1/2) 2716-002 or 2736-004
2703-006 Flat 25 0 to 6.4 (0 to 1/4) 2716-002 or 2736-004
2703-007 Flat 25 6.4 to 12.7 (1/4 to 1/2) 2716-002 or 2736-004
2703-004 Vee 16 7 to 12.7 (9/32 to 1/2) 2716-002 or 2736-004
2703-008 Vee 25 3.5 to 8 (1/8 to 5/16) 2716-002 or 2736-004
2703-009 Vee 25 7 to 12.7 (9/32 to 1/2) 2716-002 or 2736-004
2703-010 Vee 25 12.7 to 19 (1/2 to 3/4) 2716-002 or 2736-004
2703-070 Round 16 12.7 to 15.8 (1/2 to 5/8) 2716-002 or 2736-004
2703-071 Round 16 15.8 to 19 (5.8 to 3/4) 2716-002 or 2736-004
2703-011 Flat 16 0 to 6.4 (0 to 1/4) 2716-003, 2716-008, or
2736-005
2703-012 Flat 16 6.4 to 12.7 (1/4 to 1/2) 2716-003, 2716-008, or
2736-005
2703-013 Vee 25 3.5 to 8 (1/8 to 5/16) 2716-003, 2716-008, or
2736-005
2703-014 Vee 25 7 to 12.7 (9/32 to 1/2) 2716-003, 2716-008, or
2736-005
2703-015 Vee 25 12.7 to 19 (1/2 to 3/4) 2716-003, 2716-008, or
2736-005
2703-072 Round 16 12.7 to 15.8 (1/2 to 5/8) 2716-003, 2716-008, or
2736-005
2703-073 Round 16 15.8 to 19 (5.8 to 3/4) 2716-003, 2716-008, or
2736-005