41
Frame
Product Support:
Computer system and controlling software
The computer system is the operator communication link with the various system controls and the frame.
Operators enter information and control parameters into the computer by way of the controlling software
package.
The 59 Series control unit receives messages from the computer and sends the message to the testing
system to perform the required operation. While testing, the controller receives data from the load and
position transducers on the frame and sends the data to the computer. A frame interface board mounted
inside the control unit provides signal interfacing between the controller and the system components.
Communication between the 59 Series control unit and the computer is accomplished through an
Ethernet Frame Interface (EFI) that is mounted inside the 59 Series control unit.
For detailed information on the computer system, please refer to the computer manufacturer’s literature
that was provided with the system. For more information on the controlling software, refer to the
software’s On-line Help system or to the manual provided.
Electrical panel
Warning
System electronics are mounted on an electrical panel. The panel is mounted inside the electrical box on
the side of the console. The electrical panel houses a motor starter for the electric motor in the HPS and
an overload relay for the motor.
Computer systems are typically purchased from Instron with the testing system, however they may be
customer supplied. If this is the case, refer to any information provided by the computer vendor in
regards to its operation, warranty, etc. Instron is not responsible for customer supplied equipment.
Disconnect the electrical power supply before removing the covers to electrical equipment.
Disconnect equipment from the electrical power supply before removing any electrical
safety covers to replace fuses, inspect or clean the system. Do not reconnect the power
source while the covers are removed. Refit covers as soon as possible.
