![background image](http://html1.mh-extra.com/html/insteon/2633-422/2633-422_owners-manual_2069891007.webp)
Page 7 of 14 Rev: 1/8/2013 7:36 PM
3) Adjust On/Off Module to desired level (on or off)
4) Press and hold On/Off Module set button until it double-beeps
5) For each additional scene member:
a) Adjust member to desired scene brightness
b) Press and hold set button until it double-beeps
6) Tap controller set button
Controller will beep and LED will stop blinking
7) Test by tapping controller button on and off
On/Off Module and other scene responders will all respond appropriately
Make On/Off Module a Controller of Multiple Responders
1) Press and hold On/Off Module set button until it beeps
LED will start blinking green
2) Tap On/Off Module set button
LED will start double-blinking green
3) For each responder you are adding:
a) Adjust responder to desired scene brightness/state
b) Press and hold set button until it double-beeps
4) Tap On/Off Module set button
On/Off Module will beep and LED will stop blinking
5) Test by tapping On/Off Module paddle on and off
All the responders will turn on and off
Remove On/Off Module as a Controller
If you no longer want On/Off Module to control another device (or are removing On/Off Module from your
network) it is important that you follow the instructions below for each responder.
1) Press and hold On/Off Module set button until it beeps
LED will start blinking green
2) Press and hold On/Off Module set button until it beeps a second time
LED will start blinking red
3) Press and hold responder set button until it double-beeps
On/Off Module will double-beep
and LED will stop blinking
4) Test by tapping On/Off Module on and off
Former responder will not respond
Remove On/Off Module as a Responder
If you no longer want a controller button to control On/Off Module, follow these directions.
Note
: If you ever wish to uninstall On/Off Module, it is important that you remove all On/Off Module
responder links. Otherwise, controllers will repetitively retry commands, creating network delays.
1) Press and hold controller button until it beeps
LED will start blinking green
2) Press and hold controller button until it beeps a second time
LED will start blinking red
3) Press and hold On/Off Module set button until it double-beeps
Controller LED will stop blinking
4) Test by tapping controller button on and off
On/Off Module will no longer respond