INSTEON 2421-222, Owner'S Manual, Page: 8 / 12

Open/Close Sensor Owner’s Manual
Page 8 of 12
Using Open/Close Sensor’s Multi-Scene Mode
In multi-acene mode, Open/Close Sensor will:
• Activate scene 1 when it opens
• Activate scene 2 when it closes
This mode is ideal when you need more flexibility:
• For rooms where you want the lights left on after the door is closed – simply don’t Link any
Responders to scene 2 in this case
• Turning lights on at full-bright when a door is opened and dim when the door is closed
• Activating two independent scenes when a door/window is opened as opposed to closed
Linking in Multi-Scene Mode
1) Open the Open/Close Sensor cover and ensure the jumper is uninstalled (or removed). When
uninstalling the jumper, the battery will need to be removed and then reinstalled for the new jumper
setting to take effect
2) Move the Open/Close Sensor magnet away from the main case, putting it in the open state
If Open/Close Sensor was closed, its status LED will flash once
3) Link the desired responders for when Open/Close Sensor opens (scene 1). See Make Open/Close
Sensor a Controller.
Scene 1 will activate whenever Open/Close Sensor is opened and will toggle on and off when Set
button is tapped (while Open/Close Sensor is opened)
4) Move the Open/Close Sensor magnet close to the main case, putting it in the closed state
Open/Close Sensor status LED will flash once
5) Link the desired responders for when Open/Close Sensor opens (scene 2)
Scene 2 will activate whenever Open/Close Sensor is closed and will toggle on and off when Set
button is tapped (while Open/Close Sensor is closed)
6) Test that the responders are working as expected by opening and closing your door or window
Scene 1 will activate when the door or window is opened and scene 2 will activate when closed
Unlinking in Multi-Scene Mode
1) Open the Open/Close Sensor cover and ensure the jumper is uninstalled (or removed)
2) Move the Open/Close Sensor magnet away from the main case, putting it in the open state
If Open/Close Sensor was closed, its status LED will flash once
3) Unlink the desired responders from scene 1. See Unlinking an INSTEON Responder from
Open/Close Sensor.
Responders will no longer respond when Open/Close Sensor is opened or Set button is tapped
4) Move the Open/Close Sensor magnet close to the main case, putting it in the closed state
Open/Close Sensor status LED will flash once
5) Unlink the desired responders from scene 2
Responders will no longer respond when Open/Close Sensor is closed or Set button is tapped
6) Test by opening and closing your door or window
Responders will no longer respond when Open/Close Sensor is opened or closed