ASSEMBLY INSTRUCTIONS FOR CHAIR MODEL
RTA-M101
PARTS LIST
ATTENTION:
Before you begin the assembly, make sure
that all parts are included in good condition.
ATTENTION:
Follow the instructions step by step.
To avoid misalignments, leave the screws loose and do not tighten them until all are in their respective places.
Do not overtighten or force the screws as they could break, strip, or damage the threads of the holes.
Using the wrong size of screws on a part could result in damage to the screw or the part.
6
A
Backrest, x1
B
Seat, x1
C
Backrest
Support, x1
D
Mechanism,
x1
E
Hydraulic
Gas Lift, x1
F
Covers for
Gas Lift,
x1 set
G
Star Base,
x1
H
Caster, x5
1
6x16mm,
x4
2
6x25mm,
x2
3
3B: Metal Bracket
4
Screw Knob
x1
5
8x20mm
x1
6
Allen
wrench, x1
STEP 1
Insert the casters (F) into the legs of the
base (C) using pressure, then place
the gas lift (E) in the middle of the base,
and cover it with (H) as shown.
STEP 2
With the seat positioned as shown,
assemble the mechanism (D) to the seat
(B) using screws (1) as shown. The handle
will be located on the RIGHT when the
chair is finished.
STEP 3
Assemble the support (G) to the
backrest (A) using the cover set (3)
and screws (2) as shown.
STEP 4
Secure the support (G) to the
mechanism (D) using screw knob (4)
and screw (5) as shown.
STEP 5
Place the top over the base, making
sure the tip of the gas lift enters into
the hole of the mechanism.
Make sure that
all the screws
are tightened
before you sit
on the chair for
the first time.
Back cover,
x1 SET
3A: Plastic cover
1
D
B
A
G
3B
2
NOTE:
3A
3B
G
IDA-M101
