3
ASSEMBLY
1. Remove contents from the box.
2. Line up the holes from the core engine to the bottom assembly, then twist to lock.
3. Line up the holes from the core engine to the top assembly, then twist to lock.
4. Attach the agitator to the core engine by lining up the hole on in the centre of the agitator with the
plastic rod on the top of the core engine. Push to lock.
5. Plug A/C adapter in at rear of core engine and plug into wall.
OPERATION INSTRUCTIONS
NOTE: TT BUDDY® should only be used with 40mm table tennis balls.
1. Before turning on the TT BUDDY®, make sure that there are no table tennis balls inside the core
engine. Rotate agitator so that the notch in the agitator is not lined up with ball entry hole. This will
reduce the possibility of jamming.
2. Place table tennis balls into top assembly.
3. Place TT BUDDY® at the opposite end of the table.
4. Set the remote control on your end of the table and turn the power button until the green light
illuminates.
5. Adjust each dial to your liking. Review the instructions below on how to customize the spin on the
ball.
REMOTE CONTROL
The TT BUDDY® comes with a wired remote control that helps you maximize the use of your TT
BUDDY®. Customize your TT BUDDY experience by using the remote to turn it on, adjust the
frequency, alter the spins, control the oscillation, and vary the projection distance. The frequency
adjuster also turns the TT BUDDY® on and off.
SPIN ADJUSTPENT
TT BUDDY Pro is designed to offer you maximum control in creating your own table tennis
experience. Use the wired remote to adjust for the desired amount and type of spin. Here is how it
works:
The two dials on the remote control marked ‘Topspin’ and ‘Backspin’ determine how fast the top and
bottom projection wheels spin. To create a topspin ball, minimize the amount of backspin and increase
the topspin position on the dial. To create a no spin or knuckle ball, place both dials around the same
speed setting. To create a backspin ball, increase the backspin on the dial and decrease the topspin.
PROJECTION DISTANCE
Projection distance of the balls on the table can be adjusted using the wired remote as well. As
explained in the spin adjustment section, this feature is also dependent on the spin settings. To
increase the distance of the projected ball, increase the backspin dial. To decrease the distance of the
ball projected, lower the spin of the backspin dial. Regarding spin, adjust the topspin dial as necessary
to accommodate the location of the backspin dial.
TABLE POSITION/OSCILLATION
Since the TT BUDDY® is so compact, users can easily move it around on the table to create their
ideal shot. Place the TT BUDDY® near the corner to maximize the angles or place the TT BUDDY® at