41
High Efficiency Top Load Washer
www.insigniaproducts.com
Washer stops
• Make sure that the power outlet is a working outlet.
• Close the lid, then press the
/Start/Pause
button to start
your washer. For your safety, your washer doesn’t spin unless
the lid is closed.
• Before your washer starts to fill, it makes a series of clicking
noises to make sure that the lid is locked and to do a quick
drain.
• Sometimes your washer may pause between stages in the
cycle. Wait to see if your washer starts again.
• Disconnect the inlet hoses and clean the hose filter screens
periodically. The screens may be clogged.
• Check the fuse or reset the circuit breaker.
Lid is locked or
doesn’t open
• Press the
/Start/Pause
button to pause your washer. You
can’t open the lid if your washer is running.
• After you pause your washer, it may take a few seconds for the
lid lock to release.
• If the lid is locked when your washer isn’t running, press the
/Power
button to turn on your washer.
• If power fails while your washer is running, the lid unlocks
when power is restored. Your washer waits three minutes, then
runs the rest of the cycle.
Washer doesn’t
drain or spin
• Close the lid, then press the
/Start/Pause
button to start
your washer. For your safety, your washer doesn’t spin unless
the lid is closed.
• Make sure that the drain hose isn’t kinked. Straighten as
necessary.
• Make sure that the height of the drain hose is within specified
limits. See Drainage requirements on page 20.
• Check the fuse or reset the circuit breaker.
• The pipes to your sewer system may be clogged. Contact a
plumber or qualified repair professional.
The water
temperature isn’t
correct
• Make sure that you’ve selected the correct temperature.
• Make sure that the water source faucets are fully opened.
• Make sure that the hoses are connected to the correct faucet
and water intake connections on your washer, then flush the
lines. See Step 2: Connect the water hoses on page 21.
• Disconnect the hoses and clean the hose filter screens. The
hose may be clogged.
Load is too wet at
the end of the
cycle
• Use a high-efficiency detergent to reduce over-sudsing. See
Step 1: Selecting a detergent on page 32.
• The load may be too small. Very small loads (one or two items)
may become unbalanced and not spin out completely.
PROBLEM
SOLUTION