www.insigniaproducts.com
10
3.7 Cu. Ft. Free-Standing Gas Range for RVs
Gas and electric location requirements
Important notes to the installer:
1
Read this manual before installing the range.
2
Observe all governing codes and ordinances.
3
Make sure that you leave these instructions with the range.
4
Before installing the range in an area covered with linoleum or any synthetic floor covering, make sure that the floor
covering can withstand temperatures at least 90°F (32°C) above room temperature without shrinking, warping, or
discoloring.
5
Do not install the range over carpeting unless you place an insulating pad or sheet of 1/4-in. (.64 cm) thick plywood
between the range and carpeting.
Before installing the range
• Remove the exterior and interior packing.
• Wipe the surfaces of the range with a damp cloth or sponge, then wipe them dry with a clean, dry cloth.
Adjusting the height and leveling the range
The range should be the same height as the adjacent countertops or workspaces. The range should also be level. If the
range is not level, the door may not close or seal correctly which can cause uneven heating and gas wastage problems.
• To adjust the height and level the range, turn the feet clockwise (to raise) the range or counter-clockwise (to lower).
Note:
To make it easier to adjust the feet, have someone push against the top of the range to tilt it slightly.
2"
(5.1 cm)
2" (5.1 cm)
8.6" (21.8 cm)
24.8" (63 cm)
8.5" (21.6 cm)
24.5" (62.2 cm)
2" (5.1 cm)
