6
NS-F16F7-CH
www.insigniaproducts.com
Assembling your fan
Tools needed but not included in the package
Assembling the tripod
1
Remove the tripod legs and connecting rods from the box.
2
Remove the wing nuts from the plastic bag attached to the front page
of the instruction manual.
3
Attach the connecting rods to the tripod legs by placing the holes on
the ends of the rods onto the wing screws attached to the tripod legs
(as shown below), then secure with the wing nuts.
Assembling the fan head
1
Separate the front and rear guards if they are connected.
2
Remove the two screws from the top of the tripod and the long screw
and washer from the fan neck.
Important
There is a rubber ring on the support tube when you remove the
fan head from the package. Keep the rubber ring on the tube
when you assemble the fan.
Phillips screwdriver
NS-F16F7-CH_15-0900_MAN_V1_ENG.fm Page 6 Friday, February 5, 2016 11:40 AM
