Insignia NS-24D310MX17, User Manual

Page: 67 / 80

63
24" 720p 60Hz LED TV
www.insigniaproducts.com
10 Highlight OK , then press ENTER .
While your TV installs the firmware update, your
TV displays a status screen.
Do not turn off your
TV until the update is complete.
11 When the update is complete, unplug the USB
flash drive, then press
ENTER . Your TV turns off
then on to complete the update.
12 If the channel list has been deleted, you need to
scan for channels. For more information, see
Automatically scanning for channels on page 46 .
Customizing TV settings
If you did not complete the customization part of the
Easy Setup wizard the first time you turned on your TV,
you can run the wizard again to customize settings.
1 Press MENU .
2 Press W or X to highlight HELP , then press T or
ENTER .
3 Press S or T to highlight Customize my TV , then
press ENTER or X . A message asks if you want to
run the Easy Setup wizard.
4 Press S or T to select OK (to reset) or Cancel (to
not reset), then press ENTER .
If you select OK , your TV turns off, then turns on
again. Go through the Easy Setup wizard. For more
information, see Turning on your TV for the first
time on page 31 .
OR
If you select Cancel or press MENU , your TV
returns to the Help menu without making any
changes.
OR
If you press EXIT , the on-screen menu closes
without making any changes.
Testing the TV speakers
You can test your TV’s speakers to make sure they are
working correctly.
1 Press MENU .
2 Press
W
or
X
to highlight HELP , then press
T
or
ENTER .
3 Press
S
or
T
to highlight TV Speaker Test , then
press ENTER or
X
.
4 Press ENTER . Your TV tests the left speaker, then
the right speaker. You hear a tone, and as each
speaker is tested, its icon turns yellow.
If one or both of the speakers fail the test, see
Video and audio on page 64 .
Note
• If you see a message that says the
firmware file is incorrect, make sure
that you have downloaded the correct
file for your model.
• If you see a message that says the
update failed or the TV screen is blank
and the power LED is blinking red
then blue, turn off your TV, turn it back
on, then run the upgrade again.