page 7
Digital Projection INSIGHT 4K Dual LED & Quad Series
Installation and Quick-Start Guide
PROJECTOR OVERVIEW
Rev B June 2016
Keypad
1
POWER ON/OFF (with indicator)
2
FOCUS
Use with the arrow keys to adjust focus.
Press to enter FOCUS ADJUSTMENT mode, then press an
arrow key to focus the image.
To exit FOCUS ADJUSTMENT mode, press
EXIT
or wait 10
seconds.
3
SHIFT
Use with the arrow keys to move the projected image.
Press to enter SHIFT ADJUSTMENT mode, then press an
arrow key to move the image.
To exit SHIFT ADJUSTMENT mode, press
EXIT
or wait 10
seconds.
4
ZOOM
Use with the arrow keys to zoom the image in or out.
Press to enter ZOOM ADJUSTMENT mode, then press an
arrow key to zoom the image.
To exit ZOOM ADJUSTMENT mode, press
EXIT
or wait 10
seconds.
5
Arrow keys
Use with
FOCUS
,
SHIFT
and
ZOOM
to make adjustments.
6
EXIT
Use to exit lens adjustment modes.
7
SHUTTER OPEN/CLOSE (with indicator)
8
RPY
Press, then press
RIGHT
to calibrate zoom.
Press, then press
LEFT
to calibrate focus.
9
INPUT +
Switches to the next available input source. Cycle through
the inputs in the following order:
...HDMI A, HDMI B, DisplayPort A, DisplayPort B...
10
INPUT –
Switches to the previous available input source. Cycle
through the inputs in the following order:
...DisplayPort B, DisplayPort A, HDMI B, HDMI A...
Notes
Keys that are not used in this
configuration are grayed out.
When adjusting focus or zoom, UP
and LEFT will focus/zoom in, while
DOWN and RIGHT will zoom out.
When adjusting shift, each arrow
key moves the image in the
corresponding direction on the
screen.
When a new lens is fitted, a
calibration procedure must be
carried out. For more information,
further in this guide.
CTRL
FOCUS
AUTO
INFO
SHIFT
ZOOM
MENU
INPUT
OK
EXIT
INPUT
OFF
ON
OSD
ON
OFF
POWER
OPEN
CLOSE
SHUTTER
+
–
RPY
1
5
10
3
4
2
9
7
8
6
