1.23.14 05469E © Inovonics, 2014 - www.inovonics.com
EN1262 EchoStream® Passive Infrared Motion
Detector
Installation and Operation Manual
1 Overview
The EN1262 is a low-current motion detector highly sensitive to moving
heat (infrared radiation) sources.
1.1 Inovonics Contact Information
If you have any problems with this procedure, contact Inovonics technical
services:
• E-mail: [email protected]
• Phone: (800) 782-2709; (303) 939-9336
1.2 What’s in the Carton
• One Duracell DL123A 3.0V battery
• Two selection jumpers
• Two mounting drywall anchors
• Two mounting screws
• Two housing screws
• One tamper wall anchor
• One tamper rivet
1.3 Passive Infrared Motion Detector Internal
Components
Figure 1
EN1262 Components
2 Installation and Startup
2.1 Installation Notes
• These products are designed to be maintained by professional
security technicians
• Products are tested for indoor use
• All products should be manually tested weekly
2.2 Mount the Housing
1.
Insert a small flat-blade screwdriver at the tab on the bottom of the unit.
The screwdriver will enter the slot at about a 45° angle. Press
downward on the handle of the screwdriver until the latch holding the
cover to the housing base releases.
Figure 2
Open the housing
2.
Pull the circuit board attachment latch and lift the circuit board out of the
housing.
Figure 3
Circuit board attachment latch
3.
As desired install the wall tamper rivet.
Note:
Wall tamper installation is required for BSI Class VI.
a. Use a 3/16” (4.8mm) bit to drill out the tamper rivet hole index.
b. Install the tamper wall anchor in the wall where you will be mounting
the motion detector’s tamper rivet.
c. Use a hammer to tap a rivet into place in the tamper wall anchor.
Figure 4
Mounting hole indices
A
Wall tamper
selection pins
B
Housing tamper
switch
C
Frequency band
selection pin
D
Reset button
C
A
B
D
A
Tamper rivet index
B
Corner mount index
C
Wall mount index
Circuit board
attachment
latch
A
B
B
B
B
C
B
B
C
C