Inovance SV820N Series, Manual, Page: 84 / 181

- 83 -
4 Operation Panel
4
4.4 Parameter Setting
Parameter setting can be performed on the keypad of servo drive. For details on the parameters, refer to
Chapter 8. The following figure shows the keypad operation of switching the position control mode to the
speed control mode after the power is on.
Figure 4-5 Diagram for keypad operation of parameter setting
Parameter group
display
Offset display in
the group
Parameter
display
Parameter setting
completed
Servo state display
Servo ready
MODE
MODE
MODE
MODE
SET
SET
SET
● MODE: Switch the display mode and return to the upper-level menu.
●
/ : Increase or decrease the value of the current blinking digit.
● : Change the current blinking digit.
● SET: Store the current setting value or switch to the next-level menu.
When the "Done" screen is displayed after parameter setting is completed, press the MODE key to return to
the parameter group display (the "H02-00" screen).