‑
140
‑
4.2
Periodic Maintenance
4.2.1 Periodic Checklist
Table 4–3 Periodic checklist
No.
Item
Checked
1
The screws used to fix the couplings between devices
are in place.
□
2
There is no sign of overheating.
□
3
Terminal blocks are in good condition without any sign
of damage.
□
4
The clamping units of terminal blocks are in place.
□
4.2.2 Periodic Maintenance List
The electrical and electronic parts inside the servo drive may be mechanically worn
out and degraded. To keep the servo drive and servo motor in good condition,
perform parts replacement based on the replacement cycles listed in the following
table. Contact Inovance or Inovance agent before replacement to double check
whether the part needs to be replaced.
Summary of Contents for SV660P Series
