‑121‑
Note
The maximum permissible voltage and current capacity of the optocoupler output circuit
inside the servo drive are as follows:
●
Maximum voltage: 30 VDC
●
Maximum current: DC 50 mA
3.8.4 Encoder Frequency-Division Output Signals
For details on encoder frequency‑division output signals, see
The encoder frequency‑division output circuit outputs differential signals through the
differential drive. Generally, this circuit serves to provide feedback signals to the host
controller in a position control system. Use a differential or optocoupler receiving
circuit on the host controller side to receive feedback signals. The maximum output
current is 20 mA.
Summary of Contents for SV660P Series
