Scanning Documents
User Manual H12 / SCAMAX® 8x1 - Version 2019.12
5.7.5.
Use of Two Output Hoppers
If the device has a 2nd Output Hopper, the Output of documents can be passed project-oriented in
both Output Trays. The most common way here is the fixed assignment of a Output Tray for a Input
Tray in conjunction with the Dual Input Hopper
(see chapter
). However, various other scenarios
are possible and reasonable.
Emptying the Output Tray is basically identical to the procedure for one Output Hopper (
see chapter
above
). When using certain configurations of
Output
(see chapter
), however, after
the change, the previously filled Output Tray is automatically lowered. Thus, the respective Stacker
Arm needs no longer to be folded up and down manually to remove the paper stack. The Output Tray
initializes back to its uppermost position as soon as this Output Hopper is reactivated.
5.7.6.
Using the Rear Output Tray
The Rear Output Tray that is attached to the rear panel,
has no Paper Guides and is limited to a document length
of about 30 cm. The ejected documents can be easily
removed by the intervention on its back side. Primarily
this should give the possibility to sort out individual do-
cuments from the actual paper stack, for example Patch
code and bar code sheets or envelopes. For the projects
designed for this purpose also the sort out of detected
double-sheet inputs to maintain the scan throughput
would be considerable. The exact instances when docu-
ments are ejected into the rear bin are defined by several
options in the
Output
section (
see chapter
) for
each scan profile.
If longer than normal documents need to be ejected to
the back, an optional, variable version of the rear output
tray may be ordered (Order No. t8xxz340), which will
accept documents of up to 62 cm in length. This tray
has a slanted design, because of space considerations.
The Rear Output Tray can be removed and reattached
easily for cleaning and maintenance purposes, or if it is
not used. For this, you simply lift the hook-shaped ex-
tensions of the Output Tray from the designated holding
pin on the back of the scanner or hang them there again.
Please note
Documents ejected into the second output bin need to have a minimum lenght of 80 mm.
