12.09.2019
4
QUICK START GUIDE : Br
ake
unit extern
2. PRECAUTION
Please read the manual before the installation, operation and inspection of the product. For the safe
operation, remind you to pay special attention to the “Warning” and “
could lead to life harm or
private loss !
*Attention
:
Attention” in the manual.
*Attention
:
The potential danger will lead to slight or medium life harm or equipment damage. It
could also warn the violate operation.
WARNING
The
potential danger
●
Do not use any brake unit and brake resistor lack of or with damaged spares.
●
Do not touch the internal spares for there are CMOS spares on the control card of the brake
unit. Otherwise it will damage the spares.
●
Please add the fan or other cooling equipment when multiple brake units installed parallel in
the one cabinet.
●
Ensure the right setting of brake unit and brake resistor.
●
Do not make voltage resistance test on the brake unit, or it will lead semiconductor spares
damaged in the main circuit of the brake unit.
●
Fix the srew when connecting, or the loose connection will lead fire or creepage.
●
Do not touch the brake unit, the internal spares and printing board after the brake unit is
connected, otherwise it will lead to electric shock. There is high voltage direct current inside.
●
Do not touch the heat sink of the brake unit and the brake resistors, otherwise it will lead to
scald or electric shock. There is high temperature and heated spares inside after the brake unit
is connected.
●
The brake resistor should be with temperature and other protection. Because the brake unit
is defective when the brake resistor keeps heated, it should have been isolated itself. Inoréa
will not take the responsibility of such accident caused by no automatic isolation.
●
The unit and brake resistor should be installed on the medium with flame retardancy.
●
Connection is allowed only when the power is switched off and completely out of power.
