Innovo® CMS 50F PLUS User Manual
11
6 Operating Guide
6.1 Using the Device
A.
Install the probe as outlined in Chapter 5.2. (Please do not use
probes made by other manufacturers as the algorithm used by
the watch will not work with them. Unapproved probes might
also damage the oximeter)
B.
Put the finger into the probe as shown in Figure 5 below.
Figure 5.
C.
Turn on the device by pushing the
button
on the panel for >1
second.
D.
User should try to stay still as much as possible during
measurement. Do not move the finger as this is the most
common reason for inaccurate measurements.
Figure 6.
E.
Wait 10-30 seconds for the pulse oximeter to be optimized. The
pulse oximeter is optimized when the plethysmograph gives a
