Smart Coin System User Manual
Page
17
of
28
Copyright © Innovative Technology Ltd 2015
GA02033
A summary of the Status Indicator Flash Codes for the payout module are shown
here:
Led Colour Status
Description
Action
Green
Flashing
1Hz
Enabled and ready to
dispense
Red
1 Flash
Hopper disabled
Host system to send
enables command.
Red
2 Flashes
Calibration Fault
Optical sensor
contaminated. Operator
to clean exit sensor light
pipe. If fault persists,
return to ITL for service.
Red
3 Flashes
No Encryption key set
Host system to negotiate
key.
Red
4 Flashes
Coin jammed
Remove power,
manually empty coins
from bowl and check
hopper base for stuck
coins. Try manually
turning the disc.
Persistent jam may
require returning to ITL
for service.
Red
5 Flashes
Fraud Attempt detected.
Reset hopper. If this
persists it indicates a
problem with the top
pay-out flap, light guide
or exit sensor.
Red
6 Flashes
Legacy, no longer used.
(Hopper empty)
Red
7 Flashes
Memory checksum error
Re-download hopper
firmware. If this persists
return to ITL for service.
Red
8 Flashes
Hopper sensors not
initialised
Return to ITL for
service.
Red
9 Flashes
Legacy, no longer used.
(Lid removed).
