Innovatech TERMINATOR-2000e, Operation And Maintenance Manual

Page: 18 / 58

INNOVATECH PRODUCTS AND EQUIPMENT CO., INC. 18
Figure 6 - Rear Weight Ballast
TRICYCLE OR CASTER WHEELBASE AND TIRES
The tricycle wheelbase allows better turning ability. The wheel bearings on the front caster roller
require lubrication with grease every 30 hours of machine operation. There are three fittings, two on
the wheel and one on the housing. When running over debris such as carpet, the carpet yarn will get
caught between the wheel and the housing. Clean out wheel and housing regularly.
The rear tires are solid rubber, tubeless, and require no maintenance. Over time, they may wear
out and need to be replaced. Before each job, inspect the rear tires and lug bolts. Tighten the lug bolts
as needed to 70 foot-pounds torque. It is important to keep the lug bolts tight.
Wheel hub should be tightened from 310 to 350 ft.-lbs. Inspect and re-torque every 60 hours of
operation. Lift machine off of floor so no weight is on wheel when re-torquing pack nut.
Figure 8 - Front Caster Wheel
Figure 7 - Rear Wheel and Packnut