ø
3/8 in.(10mm)
2 9/16 in.(65mm)
3/8in.(10mm)
Socket Wrench
(Not lncluded)
2B-2
2B-3
UP
2B-1
2B-4
A1
UP
Position arm assembly/wall
plate [01] at your desired
height, level the wall plate and
mark the pilot hole locations.
Use the hammer to knock anchors [A2]
into the wall. Be sure the anchors [A2]
are seated flush with the concrete
surface.
Drill 3 pilot holes using a 3/8 in.(10mm)
diameter drill bit. Make sure the depth is
not less than 2 9/16 in.(65mm). Never drill
into the mortar between blocks.
Install the arm assembly/wall plate [01]
using lag screws [A1] and anchors [A2].
Tighten the lag screws [A1] only until
they are pulled firmly against the wall
plate. DO NOT over-tighten the lag
screws [A1].
A2
10
