innovaphone IP DECT
Page 31
4.1.3 Configuration/ETH0-1
The Ethernet interfaces of the device can be configured here.
The structure of both menus is identical. The special features of, and differences
between, the two Ethernet interfaces (
ETH0 & ETH1
)
are explained in the text
at the relevant place within this chapter. For both Ethernet interfaces,
CAT5-STP
cables are recommended.
4.1.3.1 Configuration/ETH0-1/Link
The transmission mode of the Ethernet interface is defined here.
The
auto
transmission mode is pre-selected:
In addition, the status of the interface (
Up
or
Down
) and the Autonegation used
(for example,
100m-fdx
) are displayed.
4.1.3.2 Configuration/ETH0-1/DHCP
The DHCP function can either be disabled in
DHCP Disabled
mode or operated
in
DHCP Client
or in
DHCP Server
mode
. The DHCP function of the Ethernet
interface has four operating modes in total:
auto
Automatic selection of the transmission speed.
10m-hdx
Corresponds to 10 MBit Half Duplex.
10m-fdx
Corresponds to 10 MBit Full Duplex.
100m-hdx
Corresponds to 100 MBit Half Duplex.
100m-fdx
Corresponds to 100 MBit Full Duplex.
Disabled
The IP address and other parameters are configured manually.
Server
The IP parameters are configured manually in
DHCP Server
mode
(standard IP address
192.168.0.1
). The DHCP server
is on and should be configured accordingly as described in
chapter "
Configuration/ETH0-1/DHCP Server
”.
Client
In
DHCP Client mode
, the device receives its IP configuration
from a DHCP server to whose network the device is connected.
