Innotech Omni C14, Installation Instructions Manual

Page: 32 / 90

Omni Installation Instructions
Page 32 © Mass Electronics Pty Ltd 2017 Edition 1.2 dated 20.08.2018
3-1 Introduction
This section of the manual contains instructions and related data to facilitate the electrical
installation of the Omni System. Because of the flexibility of the Omni controllers and associated
devices can be installed in a wide variety of configurations, depending on the user’s preference.
For this reason it is not possible to include all the various installation configurations in this manual.
Instead, this manual provides examples of installations that are considered typical.
Innotech recognises that the installation examples described in this manual may not meet the user’s
requirements. However, information in this document should be used as a guide for all installations,
regardless of whether the specific circumstances match the examples given. In all cases, installation
personnel should familiarise themselves with the information contained in this section.
This section contains the following specific information:
• Electrical installation practices of a general nature
• Wiring information for Omni devices (Omni C40/20/14, Omni U10)
If required, additional installation recommendations can be provided from Innotech Control Systems upon request.
3-2 Electrical Installation Practices
This paragraph provides general information which is intended to assist qualified personnel installing
the Omni System. More detailed information for wiring of controllers and devices are contained in
subsequent paragraphs. All wiring between the controller/devices and system input/output devices,
such as sensors, fans and compressors, must be in accordance with the instructions in the applicable
instruction manual or datasheet.
Electrical power to the system must be turned off throughout the installation process. Do not apply power to any
part of the system until ready for Commissioning (see " Commissioning ").
CAUTION
If any data presented in this manual disagrees with information in the applicable instruction manual, information
in the manufacturer’s instruction manual takes precedence. Customers are encouraged to contact Innotech Control
Systems for further information or clarification of information presented herein via the contact details at the back
of this document.