35
InnoMedia, Inc
.
All Right Reserved
Configuring SIP Device via Telnet Interface
Before You Begin
Before you preceding the following, make sure you have performed the steps outlined in
the "
Setting up Your Computer" section in Chapter 1. From a windows machine open a Dos
Box. Type in Telnet 192.168.99.1, then press enter.
Logging In
Please note that command line interface is case sensitive. Type the commands in bold face
and
match case as in the samples.
Help (H)
Command "H" prompts for Username and Password for users to login and also displays a
list of the SIP Device commands.
SAMPLE:
H
Enter Username:
Admin
Enter Password:
password
C: Configuration: Operation Database
Cd: Configuring VoIP DigitMap
Cj: Configuring Jitter Buffer Size
Ct: Configure FXS Setting Parameters
Cs: Configuring SIP Settings
Cu: Configuring User Account Database
Cv: Configure VLAN Setting
Cr: Enable/Disable Polarity Reversal
C3: Enable/Disable Call Features
Cx: Configuring DMS
Cp: Configuring end dial digit(#)
C: Configuration: IP Information
Cf: Display the Current IP Information
Ci: Configure the IP Information
Cw: Change Password
E: Exiting and Logout
G: Voice Volume Control
Ga: Set Voice Volume for Each Channel
H: Help Menu
I: Information About this System
Id: Display VoIP DigitMap
Ig: Display Voice Volume Level
