8
Rear Panel
The ADSL WLAN Router is equipped with Connectors/Switches on the rear panel as
shown in the picture below:
The ADSL WLAN Router is equipped with Connectors on the rear panel as described in
the table below (from left to right):
Connector
Desription
1
DSL
RJ-11 connector for DSL
2
Ethernet 1-4
Ethernet RJ-45 connector (LAN 1-4)
3
Power
9VAC Power connector
4
WPS
Reset
Hold and press it for 1 seconds to connect WPS
Hold and press it 7 seconds to reset to factory defaults.
5
Switch
Power switch
6
Antenna
Two Antenna connectors
System Requirement
To access the ADSL Router via Ethernet, the host computer must meet the following
requirements:
With Ethernet network interface
Must have TCP/IP installed
Set client PC with obtain an IP address automatically or set fix IP address
With a web browser installed: (for example: Internet Explorer, FireFox, Opera,
Chrome, etc).
The ADSL Router is configured with the default IP address of 192.168.1.1 and subnet
mask of 255.255.255.0. As the DHCP server is Enable by default, The DHCP clients
should be able to access the ADSL Router. Or you could assign an IP address to the host
PC first for initial configuration.
You also can manage the ADSL Router through a web browser-based manager: ADSL
ROUTER CONTROL PANEL. The ADSL Router manager uses the HTTP protocol via a web
browser to allow you to set up and manage the device
.
1
2
3 4 5 6
6
