Inmes FF-325 PLUS, Operation Manual

Page: 18 / 62

INMES Industrial Ltda – Sliding table saw FF-325 Plus 16
5. SETTINGS
When handling saw blades, always wear gloves for protection.
5.1 Scratch Adjustment (Pic. 5.1)
When cutting panels covered with finishing
materials, the use of scribe D is required.
Position the scribe blade to have a 1-1.5mm
depth cut.
Proceed as described in this manual if necessary to
adjust the striker to the blade.
- Loosen handle A and adjust the height of the saw
blade using handle C.
- Loosen handle B and adjust the scribe saw
sideways so that it aligns with the main saw using
handle D.
(Pic. 5.1)
5.2 Extension table level adjustment (Pic. 5.2)
Tools Required:
- Scale.
- Backlash Calibrator.
- Allen4mm wrench.
13mm mouth spanner.
- Spanner17mm.
- Place the ruler B on the main table and the
extension table. Use the Reg to check the
unevenness formed.
- Loosen screws A moderately using the 17mm
wrench.
- Loosen nut C using 13mm wrench and adjust table
by turning screw D using 4mm Allen wrench.
- Retighten all screws A.
- Retighten all C nuts.
(Pic. 5.2)
For each saw height adjustment, check the alignment of the tracker. If necessary adjust.