Flex2R/2T | © 2021 Inim Electronics S.r.l.
3
1. Description of Flex2R/2T
The Flex2R/2T is an expansion device that provides INIM control panels with a further four terminals.
T1 and T2
Two I/O terminals, which can be configured as:
l
Zone (also as roller blind/shock)
l
Open Collector output
l
I/O terminal
l
Double zone
SW1 and SW2
Two relay output terminals, dry contacts normally open whose status is replicated by the two LEDs ‘SW1’
and ‘SW2’ (the LEDs activate in the event of closed contact).
Peripherals
As a control panel peripheral, Flex2R/2T requires connection via I-BUS as well as an address. Sub-
sequently, the operating mode must be selected via the Prime/STUDIO software, which also allows the pro-
gramming of terminals.
