3. Programming of Flex2R/2T
3. Programming of Flex2R/2T
The programming of Flex2R/2T devices, as peripherals of the Inim Electronics control panel, can be carried
out either via software or from a keypad.
3.1 Programming of home-automation modules
Via software
By clicking on the ‘Home-automation modules’ button on the menu on the left, the sec-
tion on the right will show the list of all the configured modules.
Selecting one of the options will allow you to configure the parameters of the single peri-
pheral by clicking on the
button.
Via keypad
Type in Code
(Installer)
, PROGRAMMING Home-automation modules, ChoosePeripheral
This section allows you to program the various options of the selected module.
3.1.1 Parameters of Home-automation modules
The parameters of a home-automation module differ, depending on the functions it is programmed for.
Parameter
Software section
Installer menu section
Description
This string identifies the home-automation
module, customizable by the installer.
Configured home-automation
modules, selected module
HomeAutom.module, Choo-
sePeripheral, "module",
Description
Generic
Roller blind
Lights
Option to enable one of the operating modes
of the selected module.
/
Operating
type
Checkbox for the selection of the operating
mode
Depending on the type of operation, addi-
tional parameters are available:
/
Roll up time
in mS, from 1 to 200
seconds
/
Roll down time
in mS, from 1 to 200
seconds
/
Additional roll up/roll
down time
in mS, from 0 to 20
seconds
/
Pulse time of Vene-
tian blind rotation
in mS, from 1 to 10
seconds
/
Number of Venetian
blind pulses
from 0 to 4
/
Note
In the case of programming the device to control roller-shutters, it is necessary to enter, as accurately as possible,
the times for up/down and Venetian blinds movement.
18
Installation and programming manual- 101
